The EVO 4 can set two channels in the same Smartgain pass. The result is only as useful as the level you let it hear. For a two-person voice session, rehearse a loud moment on purpose, test each track alone and keep enough headroom for an unexpected laugh.
- Map each voice to one channel
- Select both inputs for Smartgain
- Rehearse the loudest exchange
- Listen back to both mono files
Assign and verify two inputs
Audient documents separate numbered input controls and Smartgain for one or both channels. Use two rear XLR inputs for two microphones and record one mono track per person. If you plug a jack into the front instrument input, it overrides rear analog input 1. Check power requirements for each mic and enable phantom power only on the selected input that requires it. Keep monitor level low while making changes. Audient EVO 4 input controls and Smartgain · EVO 4 hardware and input routing.
Run Smartgain with a useful sample
Select both inputs for Smartgain and perform an exchange representative of the recording. Each person should speak at their usual distance. Have each deliver one emphatic line instead of whispering through the setup. Leave the microphones in those positions afterward. If Smartgain signals failure or one channel appears silent, check that mic’s connection, channel selection, input level and phantom power before running it again.
Make a 30-second proof
Record the first person alone, then the second, then a normal overlap and a short quiet pause. Stop and listen to each mono track separately. Hearing the other person faintly may be ordinary acoustic spill, but the dominant voice should belong to the track’s listed source. Lower gain on the offending channel if a loud peak clips. Move the microphones or people if spill outweighs the gain problem.
Fix the headphones without moving input gain
Use Monitor Mix to balance the direct signals with playback and keep its job separate from gain. If both people report a delayed or doubled voice, check whether the DAW and hardware are monitoring the same input at once. If only one participant is quiet in the file, correct source distance or that channel’s gain, not the master headphone level.
Save enough to repeat the test
Label both physical channels and store the rehearsal clip with the session setup. Next time, compare one loud line with yesterday’s capture, and don’t treat the automatic setting as mandatory if a manual adjustment works better. For guests who move around, a clear distance cue and a short rehearsal are more useful than attempting to repair heavily clipped audio after the conversation.
Twin Studios does not sell this equipment. This guide does not contain affiliate links or claims about specific Twin Studios sessions.