With an amp simulator, the guitar tone you hear in your headphones does not have to be the tone you commit to disk. Set the SSL 2 MKII’s monitoring path deliberately and check your DAW before a real take, because a clean direct feed alongside a delayed software tone can make even a good performance feel wrong.
- Plug into the front instrument input
- Arm the corresponding mono track
- Listen to the DAW return only
- Confirm the dry file on playback
Separate the routes
SSL’s user guide documents a monitor mix that blends the direct inputs with the DAW return, and describes monitoring software effects like an amp simulation. This guide is for SSL 2 MKII, not SSL 2+ MKII. Start with the front high-impedance input for direct guitar, an armed mono DAW track for that channel, and listening levels down while you connect. SSL 2 MKII user guide.
First record a dry baseline
Leave input processing such as the interface’s Legacy 4K switch off for your baseline and check hard-picked notes at the input meters. Put the amp simulator on the armed track and enable the DAW’s input monitoring. Turn the SSL monitor mix toward the USB playback side to reduce the parallel dry monitor path. Keep the software output under control so a louder simulator doesn’t make you compensate at the input preamp.
Prove you can change the sound later
Record a short riff with the simulator audible. Stop, turn input monitoring off and play that clip. Bypass the simulator on playback. If you now hear a clean DI, you have confirmed your routing records dry while monitoring processed. If the amp tone remains, check the DAW’s routing and whether you recorded a processed bus or return; a software monitoring setup cannot undo a printed effect.
Triage timing and tone separately
If playing feels late, try a smaller audio buffer and disable unnecessary high-latency plug-ins during tracking. If the sound is thin or doubled, check whether part of the direct hardware feed is still mixed in. For clean low-latency tracking instead, turn off software monitoring and blend in the direct signal. The two headphone sockets on the SSL 2 MKII share a monitor mix; don’t assume two performers can ask for separate balances. SSL 2 MKII features and shared headphone mix.
Keep one track template
Save a clean DI track with your input label, amp sim disabled by default and a note naming the monitor choice. The next time you pull it up, record a single loud chord and bypass the simulator on playback before recording the entire part. This catches routing changes after a driver or session update.
Twin Studios does not sell this equipment. This guide does not contain affiliate links or claims about specific Twin Studios sessions.