The Scarlett 2i2 4th Gen can capture a voice and a guitar as two separate tracks. The most common setup mistake is to think of its rear XLR and front jack sockets as four independent inputs. Think in channels first: pick one connection for channel 1 and one for channel 2.
Map the inputs before setting gain
Connect the vocal microphone to a rear XLR and the electric guitar to the other channel’s front jack. Select that guitar channel and enable Inst for a passive instrument plugged in directly; a line-output device instead needs line mode. Focusrite documents that inserting a front jack disables the mic input on the corresponding channel, and that 48 V applies to both XLR inputs. Check connected microphones before enabling it. Focusrite specifications and channel order · Focusrite hardware guide.
- Rear XLR on 1 → mono vocal track set to input 1.
- Front jack on 2, Inst for direct guitar → mono guitar track set to input 2.
- Headphones → either Direct Monitor or software monitoring, not both for the same input.
Use Auto Gain as a starting point
Select the channel and run Auto Gain while singing or playing at real take volume over its ten-second measurement. Repeat for the other input. Play the loudest section afterward and watch for overload rather than trusting a quiet setup pass. Clip Safe can turn the preamp down when a peak risks clipping, but Focusrite documents that it is unavailable above 96 kHz. Focusrite: Auto Gain and Clip Safe.
Record and verify a 30-second take
- Arm two mono tracks. Play guitar alone and verify the guitar track moves. Sing alone and check the vocal track. An acoustic mic can still pick up some real guitar sound in the room.
- Play and sing together. Stop, switch off input monitoring and listen to each track solo to verify the routing.
- If you hear an echo only while tracking, disable track input monitoring when using Direct Monitor. For plug-in monitoring, switch Direct Monitor off and check your DAW buffer instead.
Before you buy for a larger session
Decide how many independent analog sources you’ll actually need at once. The 2i2 has two analog input channels. Loopback can capture software audio but cannot add a third mic input.
Twin Studios does not sell this equipment. This article contains no affiliate links or claims about gear used in particular Twin Studios sessions.