The iD14 MKII can grow beyond its two built-in analog channels, but the extras depend on what you plug in and how it clocks. Make a routing map before the session rather than guessing when a microphone vanishes after you plug in a bass.
- Map two analog channels
- Reserve channel 1 for front DI
- Match the optical format
- Check sync and record one input
Do not count the DI twice
Audient’s hardware guide explains that plugging into the front instrument input takes over analog channel 1 from the rear combo socket. Put a vocal mic on rear channel 2 if you want to record it separately from a plugged-in bass. Set both DAW tracks to mono and label the sources. You don’t need an optical device for that two-channel session. Audient iD14 MKII hardware and optical setup.
Configure optical expansion
The optical port is an input supporting ADAT or optical S/PDIF. Set the sending device’s format and sample rate, and configure the iD14 MKII to sync to the incoming optical clock. Higher sample rates can reduce the number of ADAT channels available. Before booking a session, confirm the receiving mixer sees the right number of channels at the sample rate you intend to use. Audient System Panel and Routing.
Do a physical channel check
Record the rear mic alone and then the DI alone. With the optical unit connected, send a low-volume test into only its first channel. Find that channel in the Audient mixer and the DAW and label it. Repeat for each input in use. If room spill is likely, listen with headphones and use one test source at a time rather than assuming the biggest meter represents the intended input.
Diagnose pops and missing sources
When all optical channels are silent, check source format, clock lock and cable direction before changing the track assignments. Periodic clicks can come from a clock mismatch; check both devices before blaming hardware. If one channel is missing but others work, trace its meter on the sender, then the mixer, then the DAW. For a missing rear analog channel 1, check the front DI jack first.
Keep the setup repeatable
Make the destination part of your notes. Write down recording sample rate, optical format, clock source, and which recorded tracks correspond to which input. If you use another digital device after the session, restore the clock source indicated by Audient for standalone analog-only operation instead of expecting the old optical clock to remain available. Before a real take, record all assigned tracks for a minute, listen back, and make sure the DAW can sustain the configuration.
Twin Studios does not sell this equipment. There are no affiliate links or Twin Studios session claims in this guide.