KRK ROKIT 5 G5: Use the Three Voicings Without Chasing Your Mix

The KRK ROKIT 5 G5 lets you change the monitor’s voicing without touching your song. That makes it useful for checking a decision, but it can also trick you into editing against three targets. Pick a baseline, make one change at a time, and reserve the other modes for answering a particular question.

Distinguish voicing from placement correction

KRK documents three voicings on the Generation Five model: Mix, Focus and Create. The rear controls also offer boundary and tuning combinations intended to address setup and room interactions. These are separate decisions. Start with the same mode and setting on both speakers, place them symmetrically at ear height, and avoid changing the placement setting in the middle of a comparison. This guide is not for a G4 or earlier ROKIT. KRK ROKIT 5 Generation Five controls · KRK manuals and downloads.

Choose one reference, then ask a question Make the first decision in Mix. Use Focus to check vocal masking. Return to Mix and a second system.Make the first decision in MixUse Focus to check vocal maskingReturn to Mix and a second system
Choose one reference, then ask a question: Make the first decision in Mix; Use Focus to check vocal masking; Return to Mix and a second system.

Run the four-minute mode test

  1. In Mix mode, play a familiar reference and a short section of your own track. Keep your playback level comfortable. Mark whether the vocal falls behind the same instrument on both tracks.
  2. Switch both monitors to Focus. Ask one question: can you distinguish the last word of each line from the guitar or keys? If an instrument masks only two words, try local automation instead of cutting its midrange across the entire song.
  3. Try Create on the same section if you want a contrasting listening perspective. Compare at similar perceived loudness. Return to Mix before accepting an EQ move, then check the change on another system you know well.

If only one side seems bright or louder

Start with a mono voice. Verify that both rear screens show the same selected voicing and that matching trims have actually been saved. Compare one cable and source output at a time with monitors down and powered off before changing connections. If a tonal issue follows the physical position rather than the cabinet, work on placement before setting different trims on each side.

Make the settings repeatable

Write down your usual mode, the relevant placement settings, the desk or stand position, and your reference passage. Save mix changes in the session, not by applying more corrections at the speaker. Twin Studios does not sell this model.

Back to blog

Leave a comment