Test static, dynamic and spectral EQ in FabFilter Pro-Q 4

Use one repeated problem phrase to decide how much equalization you need.

FabFilter Pro-Q 4 test workflow Find one resonance. Compare three modes. Match output levels.Find one resonanceCompare three modesMatch output levels
Find one resonance → Compare three modes → Match output levels.

Pick a problem that comes and goes

Loop a phrase where one vowel or note gets harsh but adjacent notes sound fine. Use the analyzer to help locate a suspect peak, then confirm by ear at a comfortable level. Don’t copy a fixed frequency from someone else’s voice. Make three copies of the same track region, or save three comparable plug-in states: static, dynamic, and spectral.

Build a fair comparison

In the static version, apply a small bell cut at the chosen range and listen for whether the good syllables lose useful tone. On the dynamic version, use a shallow downward dynamic range and watch whether gain reduction follows the problem vowel. FabFilter describes Pro-Q 4’s standard dynamic behavior as program-dependent; don’t expect a single fixed response across different audio. On the spectral version, enable Spectral Dynamics for the band and compare what happens when the resonances move within the chosen area.

Avoid the louder-is-better trap

Match playback levels and compare full sentences, not just the harsh syllable in solo. If the static cut sounds good through the whole loop, keep the simpler choice. If the static cut dulls normal notes, try ordinary dynamics first. Spectral Dynamics can selectively target components within the band, but that extra selectivity is only useful if you can hear a benefit. If the result gets papery or uneven, reduce the amount or use a wider, gentler approach.

Reproduce it

Use an eight-second vocal with two similar loud syllables, only one of which sounds sharp. Keep a dry reference. In your preferred setting the bad syllable should be less distracting and the good one still recognizable at the same level. Check the vocal with accompaniment before you print it. If you cannot reliably distinguish the improvement over two blind switches, bypass the band and revisit the microphone or arrangement instead.

First-party references

Back to blog

Leave a comment