Shure SM57: Find Your Spot on a Guitar Cabinet

With a close SM57, changing where the mic points is often more useful than reaching for EQ. The goal is not to find one universal placement. It’s to find where this speaker and this guitar leave enough space for the rest of your mix.

Set up a controlled comparison

The SM57 is a wired cardioid dynamic mic. Shure lists a frequency response of 40 Hz to 15 kHz and gives separate amplifier-miking starting points for the center and edge of the speaker. These are options to audition, not presets guaranteed to sound the same on every cabinet. Shure SM57 user guide.

Put the mic on a stand and keep it clear of the grille cloth. Identify which speaker you are using if there’s more than one. Keep the guitar, amp settings and playback level the same for each take. A looper or reamped dry part makes the experiment easier to repeat; playing the same short riff works if you don’t have either.

Change one variable per take
SM57 guitar cabinet placement test Near-center position. Record a repeatable riff. Move toward the edge. Keep distance unchanged. Compare microphone angle. Keep the preferred aiming point. Choose in the full mix. Match playback levels first.1Near-center positionRecord a repeatable riff.2Move toward the edgeKeep distance unchanged.3Compare microphone angleKeep the preferred aiming point.4Choose in the full mixMatch playback levels first.
  1. Mark a near-center and outer point on the cabinet without obstructing the grille.
  2. Keep the mic distance and angle steady while moving from one point to the other.
  3. Once you choose a point, compare straight-on and angled placements without also changing distance.

Record three short passes

  1. Make a center-side take first. Use a riff that has single notes, palm mutes and a chord. Check the loudest part before you record so the interface isn’t clipping.
  2. Move toward the edge. Keep the mic the same distance from the cabinet. Record the same riff and label the file while you still remember the position.
  3. Return to the spot you liked and change only the angle. The take you choose should be the one that works with bass, cymbals and the vocal, not just the loudest soloed sample.

Read the symptoms

If a take is fizzy, compare the edge and angled versions before cutting high frequencies. If it’s dull, move inward before boosting. If you need to exclude room sound, keep the mic close enough to favor the cabinet, then check whether moving it closer adds too much low end.

A second mic isn’t necessary to finish the take. If you add one, listen to each alone and then together in mono. If the pair sounds thinner, compare position and timing before stacking on more EQ. Keep the better single mic if it already does the job.

Twin Studios does not sell this equipment. This article contains no affiliate links or claims about gear used in particular Twin Studios sessions.

Back to blog

Leave a comment