If a singer gets lost in the band, turning the channel up isn’t always the first move. With the SM58, check mouth distance and where the loudspeakers are aimed before changing the mixer. This guide is for a wired SM58 on a small PA; the same distance exercise works while recording a demo.
Know what the mic can and can’t do
The SM58 is a cardioid moving-coil mic with a spherical grille and built-in wind and pop filtering. Shure specifies a 50 Hz to 15 kHz response. The cardioid pattern makes orientation useful, but it doesn’t stop other sounds in the room from reaching the capsule. For a simple wedge setup, aim the back of the mic toward the monitor and avoid pointing the mic at speakers. Shure SM58 user guide.
Hold the handle rather than wrapping a hand around the grille. Keep the distance to the singer fairly consistent while setting gain: if the engineer sets it while the singer is close and the singer backs away, the vocal level drops while the room and band don't get any quieter.
- SM58 → balanced XLR → mixer mic input.
- Mute or turn down speakers while connecting and setting the initial channel controls.
- Set input gain from the loudest normal line; then raise the monitor only as needed.
Run a five-minute soundcheck
- Start with channel EQ flat and effects off. Sing a chorus at gig level from a consistent close distance. The mixer should show signal without clipping on the loudest syllables.
- Repeat the same line a few inches farther away with gain unchanged. Listen for the balance of voice and band, not just the loudness difference.
- Try the closer position again. If it sounds too heavy, move back slightly or try a gentle high-pass filter; compare before adding more EQ.
- Bring the wedge up gradually. If the first ringing starts, lower the wedge and reposition it instead of pushing through the ring. Leave extra margin for the show.
If it still isn’t clear
A low howl that changes when you move the mic usually calls for a position or monitor-level change. A sharp crackle on loud words can be overload: watch the channel’s input meter and reduce gain if needed. If the meter drops when you move the cable, mute the channel before swapping in a known-good cable.
For a sit-down recording where close placement and interface gain are the decision, try our SM7B vocal test.
Twin Studios does not sell this equipment. This article contains no affiliate links or claims about gear used in particular Twin Studios sessions.