PreSonus Studio 24c: Balance Headphones Without Changing the Take

The Studio 24c’s Mixer knob controls how you listen, not the level recorded to the track. Keeping those jobs separate lets you give the singer more voice in the headphones without risking a clipped recording.

Quick workflow: PreSonus Studio 24c
Four steps for PreSonus Studio 24c Check the physical input meter. Arm the correct mono track. Blend input and backing in headphones. Play the file back without monitoring.1Check the physical input meter2Arm the correct mono track3Blend input and backing in headphones4Play the file back without monitoring
  1. Check the physical input meter
  2. Arm the correct mono track
  3. Blend input and backing in headphones
  4. Play the file back without monitoring

Trace two different controls

The Studio 24c has two front combo inputs. PreSonus describes the Mixer knob as a blend between the interface input signals and playback from the computer. Set the recording level with the input gain and look at the input meter. Then use Mixer to change the amount of live signal versus backing sent to monitoring. Adjust headphone listening level at the headphone control. PreSonus Studio 24c owner’s manual.

Start with a predictable headphone mix

Keep headphone level low at first. Select the Studio 24c for DAW input and output, and arm a mono track for the physical source. With software monitoring off, play the backing and make a sound into the microphone. Turn Mixer toward inputs to hear more direct signal, then toward playback to hear more of the track. Find a balance the performer can follow.

Prove the mix didn’t change the take

Record two short clips at the same input gain, one with Mixer nearer the input side and one nearer playback. Keep performance and mic distance steady. Turn monitoring off and compare the raw recordings. Adjusting headphone balance alone should not change the track’s recorded level. If the raw clips differ greatly, check whether the performer moved or the input gain changed during that pass.

Find echo, silence or clipping

For an echo only while tracking, use hardware direct monitoring with software input monitoring off, or software monitoring when you need an effect and the buffer permits it. If the backing plays but the mic is missing, check the physical input meter and track assignment. If the file clips even though the headphones are quiet, lower the preamp gain and retake; turning down the phones won’t repair it.

Keep the setup repeatable

Keep an audible test phrase and the raw file in your interface setup template. At the next session, play the phrase to verify playback. Speak into the mic and check its input meter to confirm capture separately. If you work with a second performer, remember the Mixer control is a blend, not a separate custom mix per input. If they need a substantially different cue, make a deliberate alternate monitor routing plan.

Twin Studios does not sell this equipment. There are no affiliate links or Twin Studios session claims in this guide.

Back to blog

Leave a comment