Audio-Technica ATH-M40x: Verify Your DJ Cue Before You Touch the Fader

You load the next track, press Cue and hear only one side of the headphones. That may be exactly what split-cue is supposed to do. Before swapping hardware or adding gain, find out whether the sound is missing in the headphones or whether the mixer is routing it somewhere else. The ATH-M40x is a wired closed-back pair with cups that swivel for one-ear checks.

Set the cable and fit first

Audio-Technica documents a 35 Ω headphone with 90-degree swiveling cups and two detachable leads: a long straight lead and a coiled one. For a desk or a booth, pick the lead that lets you turn your head without pulling the left cup out of position. Use the stereo headphone output and the matching adapter, with the phones level down while connecting. Audio-Technica M-Series leaflet · Manufacturer technical data for the M40x.

Soundcheck order Test both ears with a mono recording. Compare cue and master separately. Use one cup only for the final check.Test both ears with a mono recordingCompare cue and master separatelyUse one cup only for the final check
Soundcheck order: Test both ears with a mono recording; Compare cue and master separately; Use one cup only for the final check.

Prove the headphones can play both sides

  1. Put both cups on and play a known mono recording on a headphone output you trust. Listen quietly for a stable image in the center.
  2. On your mixer, select only the next track’s headphone cue. Start with cue/master blend on the cue side. If your mixer has split-cue, try the same setting with it off and then on. List which side carries the cue and which carries the master; the mapping can vary by mixer.
  3. Return to the expected setting, swivel one cup and compare cue timing with the room or a nearby monitor, if your setup permits. Use both cups again for a stereo check. A single swiveling cup is useful for timing, not proof of a balanced stereo mix.

If one side still drops out

Mute or turn the headphone level down; reseat the earcup connection and plug. Swap to the other included lead and repeat the first test without changing the source. If the fault follows the mixer only when split-cue is on, review mixer routing. If the same ear cuts out on a trusted stereo source with both cables, seek service instead of turning up the other ear.

Before a recording or set, jot down the identified cue mapping and cable choice. Repeat the quiet mono test whenever either changes. Twin Studios does not sell this model.

Back to blog

Leave a comment