Electro-Voice RE20: Compare Speaking Distance Before Adding EQ

The RE20 is an end-address dynamic microphone often used for voice. It is useful to test when a presenter moves nearer to the mic for emphasis and farther away between lines. The practical question is how much the voice changes at the distances you can actually keep at a desk.

Quick workflow: Electro-Voice RE20
Electro-Voice RE20 test sequence Record close with the switch flat. Move back and repeat. Match playback loudness. Try bass tilt only if useful.1Record close with the switch flat2Move back and repeat3Match playback loudness4Try bass tilt only if useful
  1. Record close with the switch flat
  2. Move back and repeat
  3. Match playback loudness
  4. Try bass tilt only if useful

Variable-D and what to expect

Electro-Voice describes the RE20 as a cardioid variable-distance design intended to reduce the bass buildup associated with close directional miking. It has a bass-tilt switch, too. Reduced proximity effect is not a promise that loudness, room quality or breath noise will stay constant. The switch shapes the microphone signal and does not remove a noisy fan or a hard wall. Electro-Voice RE20 manufacturer guide.

Set up a stable comparison

Mount the mic on a stand that stays put when you adjust it, then aim the end at your mouth. Connect it to a mic preamp and record an unprocessed mono track. Start with the switch flat. Read a repeatable ten-second passage at a close but comfortable distance, then repeat farther away at the same performance level. Include one abrupt consonant and a brief pause. Keep the mic axis and room unchanged.

Listen for three changes

First match perceived playback loudness so the closer recording does not win by default. Listen for bass changes on sustained vowels, for plosives on the close take, and for reflections on the farther one. If the best distance still has too much low end, record an additional pass with bass tilt and compare. Don't judge the switch from one especially loud or unusually soft take.

Troubleshoot the remaining noise

If breath hits the mic, change your angle and retest before reaching for an EQ. If hiss follows higher preamp gain rather than the room, compare at a useful listening volume with a different compatible preamp or inline gain stage. If fan noise gets worse when you step back, move the fan, desk or mic placement instead of raising gain. On a busy desk, isolate the stand and check that tapping a keyboard does not travel through the boom.

Make the result repeatable

Write down mic-to-mouth distance, stand height and the bass switch position with your show template. Save the least distracting take as a reference. At the next recording, listen to that reference before changing EQ. If the current take is different, check microphone angle and the room first. These two notes are more helpful for a matching pickup than a screenshot of the plug-ins alone.

Twin Studios does not sell this equipment. This guide does not contain affiliate links or claims about specific Twin Studios sessions.

Back to blog

Leave a comment