A pianist holds the last chord of each verse and pushes the chorus forward. You want to overdub percussion and give the drummer a meaningful count-in. The finished project will have a click that follows the pianist, with the original recording playing at its original speed.
Mark what you can count
Save a project copy and duplicate the original audio file before analysis. Some software stores beat analysis in the file itself. Listen once without the screen. Count the pulse and mark the first unquestionable downbeat, the chorus downbeat and the final played attack. A pickup can fall well before beat one. A rolled chord may start before the moment the band would call “one.” Mark that musical moment. Apple’s Smart Tempo editor guide
For this exercise, use a single unwarped piano track in four-four. Set the project to adapt its tempo to the performance. Hold the file at its recorded time position when changing the grid. In Logic, open the Smart Tempo editor, check the detected meter and add downbeat hints where the analysis loses the pulse. Audition a few bars before adding more hints. Other DAWs offer beat mapping or tempo markers that can produce the same result. Apple’s free-tempo recording workflow
Work from long spans to short ones
Suppose the first beat of bar 2 falls at 4.0 seconds and bar 3 begins at 6.5 seconds. The four quarter-note intervals between those downbeats take 2.5 seconds, an average of 96 beats per minute. If a detector shows 192, it may be counting eighth notes as beats. Check the accents and fix the beat interpretation before drawing a complicated series of tempo changes.
Start the metronome before the passage. If the downbeats fit but the click walks away during a held chord, add a beat hint where the pianist clearly resumes. In a passage with genuinely suspended time, a silent space and a marked re-entry may give an overdubbing musician better instructions than four invented clicks. Add a short count-in or a spoken cue on a separate guide track when needed.
Test with a musician’s part
Program a quiet shaker on quarter notes for eight bars and play it against the piano. Check the pickup, the longest hold and the first bar after it. Then mute the shaker and click and compare the piano’s final attack time and duration with the untouched reference. If the performance itself sped up, undo the stretch and adapt the project grid again. Save the map with a note marking the bars that need a visual or spoken cue.
Companion chapter · Turn a loop into a song someone can rehearse
Bedroom to Stage contents and glossary